Klim Chin Vent Casca F5 Camera Mount

The search for an integrated, low-profile helmet mount for action cameras is over. Built for cameras such as the GoPro, our F5 Chin Vent Camera Mount seamlessly replaces the stock chin vent, securely holding your camera without eliminating airflow through the vent. The centered position of the mount means your helmet isn’t off balance as it would be with a side mount, and the weight of the camera is close to the center of gravity.
INSTALLS IN PLACE OF STOCK HELMET MOUTHPIECE
ABS + POLYCARBONATE CONSTRUCTION
NO GLUE OR ADHESIVE TAPE REQUIRED
DESIGNED FOR ACTION CAMERAS SUCH AS GOPRO 5 AND NEWER
COMPATIBLE WITH GOPRO-STYLE MOUNT AND ACCESSORIES
LOW-PROFILE, CENTER MOUNT POSITION FOR BALANCED HELMET
ALLOWS FOR UP/DOWN CAMERA ANGLE ADJUSTMENT
HELMET VENTILATION IS NOT COMPROMISED
INCLUDED RETENTION TETHER ATTACHES TO CAMERA OR MOUNT
RETENTION TETHER LOOPS TO HELMET STRAP
USES EXISTING CAP NUT AND THUMB SCREW FROM CAMERA
CAP NUT INCLUDED
USES EXISTING THUMB SCREW FROM CAMERA

HOW TO USE:

REMOVE STOCK MOUTHPIECE FROM HELMET
PUSH TOP OR BOTTOM RELEASE TAB (BEHIND MESH) FROM INSIDE THE CHIN BAR
DO NOT ATTACH CAMERA UNTIL MOUNT IS INSTALLED
PUSH TOP IN FIRST, THEN PIVOT MOUNT DOWN TO SEAT BOTTOM TAB
LISTEN FOR AUDIBLE CLICK WHEN TABS SEAT INTO PLACE
CONFIRM TOP AND BOTTOM TABS ARE FULLY SEATED (BEHIND MESH)
FOR CAMERA INSTALL, USE EXISTING CAP NUT AND THUMB SCREW FROM CAMERA
TO REMOVE, PUSH THE TOP OR BOTTOM RELEASE TAB (BEHIND MESH) FROM INSIDE THE CHIN BAR